Please see video associated with this item
FROM THE INVENTOR OF NINJAFLEX........
Developed by the inventor of Ninjaflex
Flexible filament extruder retrofit kit for both left and right sides of a dual-extruder printer. Print fast with flexible materials, higher resolution, and fewer failures. Also prints ABS and PLA better than your stock extruder.
Flexible filament extruder retrofit kit for right side of dual-extruder printers. Print with flexible materials, higher resolution, and fewer failures. Your stock Mk10 left-side extruder fits in the other side. Also prints ABS and PLA better than your stock extruder.
*Does not include stepper motor
Fits all of the most common dual extruder printers - Flashforge Creator Pro, Powerspec Ultra, Monoprice Dual, QiDi Tech, Malyan M180, Wanhao Duplicator 4s, etc.
Quick Setup / Operation:
Step 2: Rotate the dial to position 4. (Confirm that the dial rotates between 1 and 4 without binding. If it binds, loosen the set screw a small amount.) At this point, you’re ready to load a filament and print. Use position 1 for very soft materials (Like Jellyfish or Ninjaflex), position 2 for moderately soft materials (like SemiFlex), position 3 for moderately hard materials (like ABS), and position 4 for very hard materials (like filled PLA). Set the correct dial location before loading filament.
Step 3: Load filament. With the dial at the correct setting and the extruder at the correct temperature, run your printer’s normal filament load cycle while you gently push the filament into the entrance liner.